Installation - Electrolux EKM60150 User Manual

48 electrolux
Burner characteristics G20 / 13 mbar - only for Russia
Burner
Auxiliary burner
Semi-rapid burner
Triple crown burner
Auxiliary
Semi-rapid
Triple crown

Installation

Warning! This appliance cannot be
positioned on a base.
The following instructions are meant for a
qualified installer, in order that the operations
of installation, regulation, and service are
executed according to the existing regula-
tions.
Whenever changes are mode involving the
disconnection of the appliance it is necessary
to proceed with maximum caution.
Warning! THE MANUFACTURING
COMPANY DECLINES ANY
RESPONSIBILITY FOR POSSIBLE
DAMAGES RESULTING FROM AN
INSTALLATION WHICH DOES NOT
COMPLY WITH THE RULES IN FORCE.
Positioning
This appliance has been designed to be
placed close to furniture units not exceeding
the height of the working level.
The distance between the hob and the side
wall/furniture (if present) should be minimum
450 mm.
Levelling
Before installing the cooker, it is necessary to
assemble the supplied feet.
1. Remove the hob pan supports, the burn-
er caps and crowns and the oven acces-
sories.
2. Carefully lean the cooker on its back, pay-
ing attention not to cause any damage.
Normal power
kW
0,9
1,4
3,0
By-pass diameters
Burner
Reduced power
kW
0,33
0,45
1,2
Ø By-pass in 1/100 mm.
3. Adjust the feet height by unscrewing the
bottom part of each foot, until you obtain
the required height (height can be adjus-
ted from 850 to 880 mm).
4. Insert the feet into the relevant holes.
5. Lift the cooker in vertical position. Re-
place the crowns, the burner caps, the
hob pan supports and the oven acces-
sories.
6. If necessary, adjust the cooker horizontal
levelling by turning the bottom part of the
feet, until the appliance is completely sta-
ble.
Normal power
Natural gas G20 - 13 mbar
inj. 100/mm
80
105
147
28
32
56
3
m /h
0,095
0,148
0,317