Advertisement
Quick Links
Advertisement
Related Manuals for Electrolux EKM 90310 X
Summary of Contents for Electrolux EKM 90310 X
- Page 1 Instructions booklet mod. EKM 90410 X EKM 90310 X...
-
Page 2: Warranty
GENERAL INFORMATION SAFEGUARDING THE ENVIRONMENT Packaging disposal Sort packaging into different materials (cardboard, polystyrene etc.) and dispose of them in accordance with local waste disposal laws. This appliance complies with the following European Directives: - 73/23/EEC regarding "Low Voltage". - 89/336/EEC regarding "Electromagnetic Disturbances". - 90/396/EEC regarding “Gas appliances”... - Page 3 COOK-TOP USE USING GAS BURNERS The following symbols are found on the control panel next to each knob: - Circle gas off - Large flame maximum setting - Small flame minimum setting The minimum position is at the end of the anti-clockwise rotation of the knob.
-
Page 4: Control Device
60 and MAX°C USING THE TURNSPIT (according to the models) TURNSPIT (mod. EKM 90310 X) To use the turnspit follow the instructions below. - Thread the chicken or cubes of meat for roasting on the spit L. Ensure... - Page 5 CARE AND MAINTENANCE turn off the mains clean appliance surfaces when still hot. under any cincumstances cooktop burners, remove by pulling upwards and soak approximately 10 minutes in hot water with a little detergent. washing them, them carefully.
- Page 6 min. 50 mm min.100 mm "0" mm Location Your cooker is heavy, so be careful when moving or positioning it. Do not try to move the cooker by pulling on the doors, handles or control panel. The cooker is designed to “slot in” between 600mm deep cabinets, spaced approximately 1000mm apart.
- Page 7 BUTANE G 30 PROPANE G 31 MINIMUM FLOW ADJUSTMENT FOR COOKTOP TAPS To adjust the minimum, turn the knob towards the minimum flow position . Remove the knob from the tap, introduce a Attention: in taps with security valve, the minimum “Z”...
- Page 8 TAP REPLACEMENT Proceed as follows: switch the appliance off, cooktop dismantle also the control panel as described in the previous paragraph. Unscrew screw nut D of the gas the burner. Unscrew screw V that secures remove it (see diagram).