Table of Contents
Advertisement
Introduction
1.4
Precautions
•
The appliance must only be used with the manufacturer's original
accessories.
•
Use the Dentsply Sirona AC adapter for this product. Never use any
other AC adapters.
•
The RPM number indicates true instrument speed when the
appropriate reduction rate is selected. Make sure the selected
reduction matches the ratio of the contra angle handpiece.
•
If the motor stops or runs too fast, discontinue use and call for
assistance.
•
After sterilization, make sure the motor has reached a temperature
below 40°C before use.
•
Do not introduce any oil into the micromotor.
•
The system functions normally in the environment where the
temperature is at 10 - 40 °C (50 - 104 °F), humidity at 10 - 85% RH,
atmospheric pressure at 700 - 1060 hPa, and no moisture
condensation in the Control Unit. Any use outside these limits may
cause malfunction.
•
Do not use a bent, damaged, deformed or non-ISO-conforming file.
Using such a file may result in personal injury due to its unexpected
breaking or "flying off" during rotation.
•
Check the product before use by rotating it, paying attention to
looseness, vibration, noise and temperature (heat generation). If
any abnormal condition is found even slightly at that time,
immediately stop use and contact your dealer.
•
Always clean the shank of the file to be installed. Allowing dirt to
enter the chuck could cause loss of concentricity and deterioration
of chucking force.
•
Before changing the head or bur, turn off the power of the motor
handpiece. Changing with the power kept on may cause
unintended rotation by accidental touch of the ON/OFF button.
•
Pay attention to the direction of batteries when setting. Forcible
setting in the wrong direction may cause damage and fluid leakage
due to a short circuit.
•
EQUIPMENT not suitable for use in the presence of a flammable
anesthetic mixture with air or with oxygen or nitrousoxide.
•
This product does not consider a patient's age, gender, weight or
nationality.
•
No special training is required for this device.
8/48
B EN XS00 DFU WEB / Rev.08 / 01-2018 (Old ZF 190270.EN)
Advertisement
Table of Contents
