Adjusting Spring Tension - Graco XD40 Repair Instructions

3. Remove large bolts (18) holding latch assembly (21)
to base (1) (F . 76). Discard latch assembly.
IG
F . 76
IG
Latch Reassembly
1. Align latch assembly (21) with reel base (1) and ori-
ent it as shown in F
IG
2. Replace bolts (18).
3. Wrench tighten bolts. Then torque to 24-35 ft. lbs
(33.9 to 46.45 N.m).
4. Remove c-clamp installed in Latch Disassembly,
Step 2.
332203F
18
. 76.
Additional Repair and Replacement Instructions

Adjusting Spring Tension

If the hose cannot be pulled all the way out or if it does
not retract all the way back onto the hose reel, you need
to adjust the spring tension.
1
• Never allow the reel to spin freely. Doing so
causes the spool to spin out of control, which
could cause serious injury if you are hit by the
21
hose or dispense valve.
• Always wear heavy, non-slippery gloves when
adjusting the spring tension to protect your hands
from being cut on the hose reel.
1. If the hose reel has been in service, relieve pres-
sure, page 10.
2. Pull the hose out far enough to engage the latch.
NOTE: Listen for the loud click when the spool has
latched.
3. Attach a c-clamp (A) to the reel spool as shown in
F . 77 to help prevent the reel from unintentionally
IG
becoming unlatched and spinning freely.
F . 77
IG
If a ball stop and dispensing device are NOT installed on
the hose end, skip Step 4 and continue instructions with
Step 5.
(A)
A
35