Table of Contents
Advertisement
15. Install the outlet (30) to the spool. Replace and
tighten all bolts (37) securely. Torque bolts to 24 to
30 ft. pounds (32.54 to 40.67 N.m) (F
NOTE:
• Low Pressure Models (shown in F
4 bolts (37).
• Medium Pressure Models (not shown) use
6 bolts (37).
• Always use all bolts provided.
30
37
F
. 12: Low Pressure Model Shown.
IG
16. Remove c-clamp (A) (installed in Step 12, page 14).
17. Disengage the latch by pulling on the hose to
release it.
Always wear heavy, non-slippery gloves when adjust-
ing the spring tension to protect your hands from
being cut on the hose reel.
18. Use your hand to guide the hose as it rewinds onto
the reel.
19. Adjust spring tension if needed. See Adjusting
Spring Tension, page 15.
20. Install the dispense valve to end of hose.
3A2990M
Adjusting Spring Tension
. 12).
If the hose cannot be pulled all the way out or if it does
IG
not retract all the way back onto the hose reel, the
spring tension needs to be adjusted.
. 12) use
IG
• Never allow the reel to spin freely. Doing so
causes the spool to spin out of control, which
could cause serious injury if you are hit by the
hose.
• Always wear heavy, non-slippery gloves when
adjusting the spring tension to protect your
hands from being cut on the hose reel.
1. If the hose reel has been in service, relieve pres-
sure, page 12.
2. Pull the hose out far enough to engage the latch.
NOTE: Listen for the loud click when the spool has
latched.
3. Attach a c-clamp (A) to the reel spool, as shown in
F
becoming unlatched and spinning freely.
F
. 13
IG
If a ball stop and dispensing device are not installed on
the hose end, skip Step 4 and continue instructions
with Step 5.
. 13, to help prevent the reel from unintentionally
IG
(A)
Installation
(A)
15
Advertisement
Table of Contents
