Additional Repair And Replacement Instructions; Removing And Installing New Hose On Reel - Graco XD40 Repair Instructions

Additional Repair and Replacement Instructions

Removing and Installing New
Hose on Reel
Use this procedure to remove the hose from the reel and
install a new hose on the bare reel. For this procedure
the spring canister is not removed from the spool.
1. Relieve pressure, page 10.
2. Verify there is sufficient access to the back of the
hose reel (opposite hose exit) to enable outlet
removal. Access is installation dependent. If hose
access is not available the hose reel must be taken
out of service. See Step 8, Remove Hose Reel
From Service, page 12.
3. Flush fluid from reel and hose.
a. Place end of hose in a waste container.
F . 53
IG
332203F
Additional Repair and Replacement Instructions
b. Blow out entire lubricant supply line with air.
F . 54
IG
c. Cap end of hose to prevent fluid spills.
• Always wear heavy, non-slippery gloves when
adjusting the spring tension to protect your hands
from being cut on the hose reel.
• Never allow the reel to spin freely. Doing so
causes the spool to spin out of control, which
could cause serious injury if you are hit by the
hose or dispense valve.
4. Pull the hose out far enough to engage the latch.
Listen for the loud click when the spool has latched.
5. Remove dispense valve and ball stop.
To remove ball stop: remove nuts (47), screws (46) and
ball stop (45) from end of hose (F
46
F . 55
IG
. 55).
IG
47
45
27