Siemens SINAMICS G110M Getting Started page 88

Distributed converter for simogear geared motors

Hide thumbs Also See for SINAMICS G110M:

Table of Contents

Commissioning

4.8 Basic commissioning with STARTER

Example of a bit pattern as trigger:

You must define the pattern and value of a bit parameter for the trigger. To do so, proceed

as follows:

Using , select "Trigger to variable - bit pattern"

Using

condition

①

②

Figure 4-19

In the example, the trace starts if DI0 and DI3 are high and DI2 is low. The state of the other

digital inputs is not relevant for the start of the trace.

Further, you can either set an alarm or fault as start condition.

, select the bit parameter

, open the screen form in which you set the bits and their values for the start

Select the bits for the trace trigger, upper row hex format, lower row binary format

Define the bits for the trace trigger, upper row hex format, lower row binary format

Bit pattern

SINAMICS G110M Getting Started

Getting Started, 09/2014, FW V4.7, A5E31298643B AC

Table of Contents