Siemens SINAMICS G110M Getting Started page 80

Distributed converter for simogear geared motors

Hide thumbs Also See for SINAMICS G110M:

Table of Contents

Commissioning

4.8 Basic commissioning with STARTER

action. For older Windows versions, acknowledge the corresponding screen forms with

OK.

3. Start the STARTER commissioning software.

4. If you are using STARTER for the first time, you must check the USB interface setting. To

do this, click in STARTER on

If the interface is appropriately set, then the "Accessible nodes" screen form lists the

converters, which are connected via the USB interface. In this case, go to Point 7.

If incorrectly set, then the "No additional nodes found" message is displayed.

5. Acknowledge this message, and set the "Access point" to "DEVICE (STARTER, Scout)"

and the "PG/PC interface" to "S7USB".

6. Then click on "Update". The connected converters are now displayed in "Accessible

nodes".

7. Close this screen form without selecting the converter(s) that has/have been found.

8. Create your STARTER project (Page 81).

You have set the USB interface.

("Accessible nodes").

Getting Started, 09/2014, FW V4.7, A5E31298643B AC

SINAMICS G110M Getting Started

Table of Contents