Sony HXC-FB80 Operating Instructions Manual page 51

OPERATION
Page name Item
Page No.
<VR ASSIGN> FRONT VR
11
REAR VR
<HEADSET MIC> INTERCOM
12 (U12)
INTERCOM1
(CAM)
INTERCOM2
(CA)
<INTERCOM> INTERCOM
RECEIVE SELECT
13 (U13)
PANEL TYPE
REAR ENC SW
REAR VR
Setting
MIC GAIN1, MIC GAIN2, MIC
GAIN1+2, INTERCOM,
EARPHONE, OFF
MIC GAIN1, MIC GAIN2, MIC
GAIN1+2, INTERCOM,
EARPHONE, OFF
DYNAMIC, CARBON,
MANUAL
LEVEL –60dB, –40dB, –20dB
–6dB, 0dB, 6dB
POWER ON, OFF
UNBAL ON, OFF
SIDE TONE MU, 1 to 99 50
DYNAMIC, CARBON,
MANUAL
LEVEL –60dB, –40dB, –20dB
–6dB, 0dB, 6dB
POWER ON, OFF
UNBAL ON, OFF
SIDE TONE MU, 1 to 99 50
DYNAMIC, CARBON,
MANUAL
LEVEL –60dB, –40dB, –20dB
–6dB, 0dB, 6dB
POWER ON, OFF
UNBAL ON, OFF
SIDE TONE MU, 1 to 99 50
SEPARATE, MIX
INTERCOM RIGHT, LEFT, BOTH, ---
0 to 99
ENG RIGHT, LEFT, BOTH, ---
0 to 99
PROD RIGHT, LEFT, BOTH, ---
0 to 99
PGM/SDI1 RIGHT, LEFT, BOTH, ---
0 to 99
SDI2 RIGHT, LEFT, BOTH, ---
0 to 99
SIDE TONE MU, 1 to 99 50
UCJ, CE
PGM1/2, PGM2, ON/OFF
INTERCOM, INTERCOM+PGM
Description / Remarks
Assigns a function to the INTERCOM LEVEL knob at the
front.
When connected to a CCU, INTERCOM is displayed (not
configurable)
Assigns a function to the INTERCOM knob at the rear.
When connected to a CCU, INTERCOM is displayed (not
configurable)
Displayed when a camera adaptor is not connected.
( ) display: When set to DYNAMIC or CARBON (not
configurable)
( ) display: When set to DYNAMIC or CARBON (not
configurable)
( ) display: When set to CARBON (not configurable)
Displayed only when a camera adaptor is connected.
( ) display: When set to DYNAMIC or CARBON (not
configurable)
( ) display: When set to DYNAMIC or CARBON (not
configurable)
( ) display: When set to CARBON (not configurable)
Displayed only when a camera adaptor is connected.
( ) display: When set to DYNAMIC or CARBON (not
configurable)
( ) display: When set to DYNAMIC or CARBON (not
configurable)
( ) display: When set to CARBON (not configurable)
When PANEL TYPE is set to UCJ
When PANEL TYPE is set to CE
When PANEL TYPE is set to CE
PGM when connected with a CCU, and SDI1 in standalone
operation mode for input audio channel 1 on SDI I/O connector
Displayed in standalone operation mode
Restart required after setting
51