Viewfinder - Sony HXC-FB80 Operating Instructions Manual

W (Wide): Wide angle.
T (Telephoto): Telephoto.
c Iris operation mode selector switch
A (Auto): The iris is adjusted automatically.
M (Manual): Adjust the iris with the iris ring.
d Iris one-push auto switch
When the iris operation mode selector switch is in the M position for
manual adjustment, press this switch for instantaneous auto iris
adjustment. The iris is automatically adjusted while the switch is
pressed.
e Iris gain adjustment trimmer
Adjust the iris gain when the iris operation mode selector switch is
in the A (Auto) position.
Flip off the rubber cap, and turn the iris gain adjustment trimmer
using a screwdriver or similar object. Rotate clockwise to increase
the gain, and rotate counterclockwise to decrease the gain.
f F.B. lock screw/F.B. adjustment ring
Use to adjust the flange back (flange focal length).
g Positioning pin
When attaching a lens, align this pin with the slot in the top center
of the lens mount on the camera.
h Macro button/macro ring
Press and hold the macro button and rotate the macro ring to focus
(close-up: 10 mm minimum).
i Iris ring
For manual iris adjustment, set the iris operation mode selector
switch to the M (manual) position, then rotate this ring.
Note
Always set the iris operation mode selector switch to the M (manual)
position before rotating the ring.
j Zoom lever/zoom ring
For manual zoom adjustment, set the zoom servo/manual selector
switch to the MANU (manual) position, then operate this lever/ring.
k Focus ring
Rotate this ring to adjust the focus.
l Zoom servo/manual selector knob
SERVO: Power (servo) zoom. Control the zoom using the zoom
see-saw switch.
MANU (Manual): Manual zoom. Control the zoom using the zoom
lever/zoom ring.
m Lens cable
Connect to the LENS connector on the camera.
n VTR button
You can assign a function to this button using LENS VTR S/S on the
<SWITCH ASSIGN2> page in the OPERATION menu.
o Zoom remote control connector
Connecting an optional zoom servo controller allows remote control
of zooming.

Viewfinder

This section describes the HDVF-L10 viewfinder supplied with the
HXC-FB80K.
For details about attaching the HDVF-L10 viewfinder, see
"Attaching and Adjusting the Viewfinder" (page 18).
For details about the viewfinder supplied with the HXC-FB80S, refer
to the operation manual for the HDVF-L750.
a Connector
Connect to the VF connector on the camera.
b Slide stopper
Prevents the viewfinder from coming off the camera when it is slid
from side to side.
c Eyecup
d Diopter adjustment ring
Rotate the ring to adjust the image for clear focus.
e Eyepiece
You can raise the eyepiece or remove it when required by the usage
situation.
f Viewfinder barrel
You can raise the viewfinder barrel or remove it when required by
the usage situation.
g Tally indicator
The indicator lights up when a red tally signal is input to the camera.
When an abnormality occurs, the tally indicator flashes to indicate a
warning.
15