Lubrication - Every 25 Hours - Craftsman C950-52919-0 Owner's Manual

Dual stag snow blower 9-h.p. 27 inch
Table of Contents

Advertisement

CUSTOMER
RESPONSIBILITIES
LUBRICATION
- EVERY
25 HOURS
Disc Drive Plate
Lubricate Disc Drive Plate every twenty-five (25) hours and
at the end of the season and/or before storage.
To Lubricate:
3.
Position speed selector lever in first (1) forward gear.
4.
Stand the snow blower up on the auger housing end.
5.
Remove the bottom panel.
6.
Turn disc drive plate clockwise by hand until grease zerk
is clearly visible at front center (see Figure 24).
7.
Place a coin or (a shim of equal thickness) between the
rubber friction wheel and disc drive plate to prevent rub-
ber friction
wheel
contacting
the
drive
disc
(see
Figure 24).
8.
To grease zerk, use a hand grease gun, lubricate with a
Hi Temp EP Moly grease. See inset of Figure 24. DO
NOT over fitl or allow grease to come in contact with the
disc drive plate or friction wheel or damage will result. Fill
zerk only until grease becomes visible below bearing as-
sembly located under grease zerk.
9.
Remove coin used in step 7. Make sure that a gap exists
between the friction wheel and the disc drive plate.
NOTE: Clean all excess grease or oil found on the
friction disc hub.
CAUTION:
Do not allow grease or oil to contact the
rubber friction wheel or the disc drive plate.
Plate
Friction
Wheel
Point at
Bearing
Assembly
which
grease
Disc
should be
Drive
visible
Plate
Shim placed in gap
___.._
Between Friction
Wheel and Disc Drive
--
_
Plate
Grease Zerk
Figure 24
Hexshaft-
wipe
with
5W30
motor oil before
storage and at the begin-
ning of each season
Chains-Lubricate
chains
with a chain type lube be-
fore storage and at the
beginning
of each sea-
son.
WARNING:
If the disc ddve
plate
or
friction
wheel
come
in
contact
with
grease
or oil damage
to
rubber friction wheel
will
result.
If grease or oil come in con-
tact with the disc drive plate
or friction wheel, make sure
to clean the plate and wheel
thoroughly
with
a alcohol
base solvent.
Use a HI Ternp EP Moley
grease
to
lubricate
grease zerk on disc drive
plate every 25 hours.
Figure 25
F-001005J
22

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents