H3C WA Series Command Reference Manual page 102

Parameters
interface-type interface-number: Interface type and interface number.
Description
Use the wlan uplink-interface command to specify an uplink interface.
Use the undo wlan uplink-interface command to remove the uplink interface.
By default, no uplink interface is configured.
If the status of all configured uplink interfaces is down, WLAN service will not be provided. If at least one
of them is up, WLAN service will be provided.
Any physical interface can be configured as an uplink interface.
You can use this command to configure multiple uplink interfaces.
Examples
# Configure GigabitEthernet 1/0/1 as an uplink interface.
<Sysname> system
[Sysname] wlan uplink-interface GigabitEthernet 1/0/1
10-27