Table of Contents
Advertisement
en Home Connect
16.4 Deactivating Wi-Fi on the
appliance
Press and hold Remote Start for
1.
approx. 3 seconds.
Press Remote Start repeatedly
2.
until the display shows "on".
Press
to deactivate the Wi-Fi.
3.
a The display shows "oFF".
Note: To exit the Home Connect set-
tings, press and hold Remote Start
for approx. 3 seconds.
16.5 Resetting the appliance
network settings
Press and hold Remote Start for
1.
approx. 3 seconds.
Press Remote Start repeatedly
2.
until the display shows rEs.
Press and hold
3.
3 seconds.
a The network settings are reset.
16.6 Remote start
Enable the appliance for remote start
via the Home Connect app.
Note
Remote start will be deactivated in
the following circumstances:
¡ The appliance door is opened.
Remote Start is pressed.
¡
¡ Following a power cut.
Activating remote start
Requirements
¡ The appliance door is closed.
¡ The detergent drawer has been
pushed in.
Press Remote Start.
▶
a Remote Start lights up and the
appliance is enabled for remote
start via the Home Connect app.
38
for approx.
Deactivating remote start
Press Remote Start.
▶
a Remote Start goes out.
16.7 Remote diagnostics
Customer Service can use Remote
Diagnostics to access your appliance
if you contact them, have your appli-
ance connected to the Home Con-
nect server and if Remote Dia-
gnostics is available in the country in
which you are using the appliance.
Tip: For further information and de-
tails about the availability of Remote
Diagnostics in your country, please
visit the service/support section of
your local website: www.home-con-
nect.com.
16.8 Data protection
Please see the information on data
protection.
The first time your appliance is
registered on a home network
connected to the Internet, your
appliance will transmit the following
types of data to the Home Connect
server (initial registration):
¡ Unique appliance identification
(consisting of appliance codes as
well as the MAC address of the
Wi-Fi communication module in-
stalled).
¡ Security certificate of the Wi-Fi
communication module (to ensure
a secure data connection).
¡ The current software and hardware
version of your appliance.
¡ Status of any previous reset to
factory settings.
This initial registration prepares the
Home Connect functions for use and
is only required when you want to
use the Home Connect functions for
the first time.
Advertisement
Table of Contents
