Table of Contents
Advertisement
Operating the appliance
en
Information on the following programme
steps and settings, which can be
changed during the programme
sequence, light up at half brightness.
Note:
Foam detection
If the Å display also lights up, the
washing machine has detected too
much foam during the washing
programme and automatically activated
additional rinse cycles to remove the
foam.
Add less detergent to the next washing
cycle with the same load.
If you want to lock the programme to
prevent it from being inadvertently
adjusted, you can select the childproof
lock as follows.
Childlock/operation lock
E 3 sec
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently in the
control panel.
To activate/deactivate the childproof
lock, touch and hold the control panel
E 3 sec for approx. three seconds. The
display switches to full brightness.
If you turn the programme selector or
touch the control panel while the
childproof lock is active, the E 3 sec
indicator flashes briefly and a signal
sounds. The programme runs through
to the end unchanged.
Notes
The childproof lock can be activated
■
regardless of the appliance's status.
The childproof lock remains active,
■
even once the washing machine has
been switched off.
If the appliance is switched off while
■
the programme is running and the
childproof lock has been activated,
the programme will resume when the
appliance is switched back on.
34
Adding laundry
After starting the programme, you can
add or remove laundry if necessary.
To do this, touch the control panel A.
The indicator flashes. The machine is
paused and checks whether it is
possible to add laundry.
If the display è goes out, it is possible
to add laundry. The door is then
unlocked and can be opened.
To continue the programme. touch A
again. The programme continues
automatically.
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
Follow the information on the display
panel.
It is not possible to add laundry
■
during the ActiveOxygen Refresh Ø
programme or when the
ActiveOxygen setting has been
selected.
The load display is not active during
■
reloading.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
Touch the control panel A.
1.
Select another programme.
2.
And touch A again.The new
3.
program starts from the beginning.
When cancelling programmes
Note:
that use active oxygen, the door will
remain locked for up to 25 minutes until
there is no longer any active oxygen in
the drum.
Advertisement
Table of Contents
