Table of Contents
Advertisement
GSP9700 Series Road Force Measurement System Operation
Place outer Dataset
data by depressing the foot pedal.
Close safety hood.
Press the green "START" button if "Hood Autostart" is disabled.
After wheel stops spinning, raise the safety hood.
Press the green "START" button with the safety hood in the RAISED position and the
GSP9700 will find TDC for the left weight plane. Mark the tire's inner sidewall for
patch placement.
Press the green "START" button with the safety hood in the RAISED position and the
GSP9700 will find TDC for the right weight plane. Mark the tire's outer sidewall for
patch placement.
Place an aligning mark on the tire and rim to align them back together after applying
the patch weights.
Remove wheel from balancer and dismount tire from rim.
Install left weight plane weighted balance patch(s) at mark(s) as instructed by
manufacturer's instructions.
Install right weight plane weighted balance patch(s) at mark(s) as instructed by
manufacturer's instructions.
Mount tire onto rim, aligning rim and tire marks.
Verify balance condition by spinning again with the load roller disabled. Refer to
"Load Roller Operation," page 60.
Finish the patch balancing procedure by returning to the appropriate balance
procedure for the type of wheel being balanced. Verify balance condition by spinning
again, and attach weights as necessary to correct for residual imbalance.
PATCH balancing procedure is complete.
®
arm roller directly over the right mark and enter
4. Balancing a Wheel • 47
Advertisement
Table of Contents
