Table of Contents
Advertisement
®
Use both Dataset
arms in the UPWARD position at the clip-on weight location to
measure the distance, diameter, and rim width dimensions. Refer to "Using the Auto
®
Dataset
Arms," page 48.
Do NOT return the arm to the "home" position.
®
Using the DOWNWARD position, move the inner Dataset
arm disk edge to the
location for placement of the right edge of the adhesive weight on the right weight
®
plane and enter data by depressing the foot pedal. Refer to "Using the Auto Dataset
Arms," page 48.
Close safety hood.
Press the green "START" button if "Hood Autostart" is disabled.
After wheel comes to a complete stop, raise safety hood.
The GSP9700 will find the TDC for the left weight plane if "Servo-Stop" is enabled.
"Servo-Stop" will hold the wheel in the TDC position while the weight is applied.
Attach the clip-on weight amount shown on the CRT for the left weight plane to the
inner rim of the wheel.
®
If necessary, use the left "
" to split the weight. Refer to "Split Weight
Feature," page 87.
42 • 4. Balancing a Wheel
GSP9700 Series Road Force Measurement System Operation
Advertisement
Table of Contents
