Hunter GSP9712 Operation Instructions Manual page 48

40 • 4. Balancing a Wheel
Select either grams or ounces by rotating the control knob and highlighting either "g"
or "oz."
Select "DYNAMIC" by rotating the control knob to highlight "
Balancing Selection," page 37.
®
Use both Dataset arms in the UPWARD position at the clip-on weight location to
measure the distance, diameter, and rim width dimensions. Refer to "Using the Auto
®
Dataset Arms," page 48.
NOTE: The Dataset
weight placement. Refer to "Measuring Dimensions for
Standard Clip-on Weight Balancing," page 49.
Enter the data by depressing the foot pedal. Release the Dataset
Close safety hood.
Press the green "START" button if "Hood Autostart" is disabled.
After wheel comes to a complete stop, raise the safety hood.
The GSP9700 will find the TDC for the left weight plane if "Servo-Stop" is enabled.
"Servo-Stop" will hold the wheel in the TDC position while the weight is applied. The
weight amount will be displayed in green.
Attach the weight amount shown on the CRT for the left weight plane to the inner rim
of the wheel.
If necessary, use the left "
Feature," page 87.
Press the green "START" button with the safety hood in the raised position and the
GSP9700 will find the TDC for the right weight plane.
®
Arms should be positioned in the location for
" to split the weight. Refer to "Split Weight
GSP9700 Series Road Force Measurement System Operation
." Refer to "Dynamic
®
arms.
®