Liebert S600 User Manual page 4

Safety Precaution
Always observe the following safety symbols!
Safety symbol
This manual contains information concerning the installation and operation of the Liebert eXM UPS
single UPS module and parallel system 80kVA ~ 200kVA.
Read this manual thoroughly before installing, using and servicing the UPS.
Important
The UPS with standard configuration is a category C3 product for commercial and industrial application
in the second environment. Installation restrictions or additional measures may be needed to prevent
disturbances.
Important
The UPS adding C2 EMC option based on the standard configuration is a category C2 product. In a
residential environment, this product may cause radio interference, in which case the user may be
required to take additional measures.
Conformity and standards
This product complies with CE 2006/95/EC (low voltage safety) and 2004/108/EC (EMC), EMC
standards of Australia and New Zealand (C-Tick), and the following UPS product standards:
* IEC62040-1 General safety requirements for UPS
* IEC62040-2-EMC
* IEC62040-3 Performance requirements and test methods
For details, refer to Chapter 11 Specifications.
Continued compliance requires installation in accordance with these instructions and the use of
manufacturer approved accessories only.
Warning
The selection of the upstream distribution protection equipment of the UPS shall be selected in
accordance with the details in 3.1.4 Selection Of UPS I/O Switch and shall comply with the local
Vertiv|Liebert® S600 10kVA ~ 20kVA UPS | User Manual
Explanation
Used for instructions intended to alert the user to
the risk of death or severe injury should the unit
be used improperly
Used for instructions intended to alert the user to
the risk of injury or equipment damage should the
unit be used improperly
Used for instructions intended to notify the user to
carefully read and observe this unit though it may
not cause damage
4