Prompt Window - Liebert S600 User Manual

4.5 Prompt Window

A prompt window is displayed during the operation of the system to alert you to certain conditions and/or to require
your confirmation of a command or other operation. Table 4-4 lists the prompts and meanings.
Prompt
System setting is different, please
check
Cannot set this online, please shut
down output
Incorrect password, please input
again
Operation failed, condition is not
met
Password changed OK
Fail to change password, please
try again
The time cannot be earlier than
system time
Turn on failed, condition is not
met
Cannot set this on line, please
unplug REPO
Please disconnect power, check
output: 1 phase, 3 phase, then
power UPS on
Vertiv|Liebert® S600 10kVA ~ 20kVA UPS | User Manual
Table 4-4 Prompts and meaning
Meaning
When the parallel parameters are different, the prompt will
appear
If the user wants to change some important settings under
condition of output (output voltage, output frequency, output phase
No.), the prompt will appear
The prompt will appear when the user incorrectly input the
Settings password
The prompt will appear when the user wants to execute a
certain operation but the condition is not met
The prompt will appear when the user successfully changes the
Settings password
The prompt will appear when the user tries to change the
Settings password but input two different new passwords
The prompt will appear when the user set the time of 'Turn on
delay' or 'Turn off delay'is earlier than the current system time
When users press the power button (or execute the command
of 'Turn on/Turn off/to Bypass' under 'Control' page), the
prompt will appear
If the user wants to change output phase No. under condition
of output, the prompt will appear
The prompt will appear when the output phase is changed. The
system requries the user to power off and check the cables
connection, then power on the UPS again to guarantee the
safety
50