Canon D1300 Series Service Manual page 146

COPIER > ADJUST > CCD
50-GB Color displacement (G and B lines) correction value in the vertical
scanning direction (50 %)
Details To correct the color displacement (G and B lines) in the vertical
scanning direction at 50% copyboard reading.
When replacing the Main Controller PCB, enter the value of service
label.
Use case When replacing the Main Controller PCB
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
Caution After the setting value is changed, write the changed value in the
service label.
Display/adj/set range -512 to 512
Unit 0.001 line
Default value 333
Supplement/memo 50 % reading: 300 dpi in horizontal scanning direction x 600 dpi in
vertical scanning direction reading mode.
100-RG Color displacement (R and G lines) correction value in the vertical
scanning direction (100 %)
Details To correct the color displacement (R and G lines) in the vertical
scanning direction at 100% copyboard reading.
When replacing the Main Controller PCB, enter the value of service
label.
Use case When replacing the Main Controller PCB
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
Caution After the setting value is changed, write the changed value in the
service label.
Display/adj/set range -512 to 512
Unit 0.001 line
Default value -333
Supplement/memo 100 % reading: 600 dpi in horizontal scanning direction x 600 dpi in
vertical scanning direction reading mode.
8
Service Mode > COPIER > ADJUST > CCD
8 Service Mode > COPIER > ADJUST > CCD
COPIER > ADJUST > CCD
100-GB Color displacement (G and B lines) correction value in the vertical
scanning direction (100 %)
Details To correct the color displacement (G and B lines) in the vertical
scanning direction at 100% copyboard reading.
When replacing the Main Controller PCB, enter the value of service
label.
Use case When replacing the Main Controller PCB
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
Caution After the setting value is changed, write the changed value in the
service label.
Display/adj/set range -512 to 512
Unit 0.001 line
Default value 333
Supplement/memo 100 % reading: 600 dpi in horizontal scanning direction x 600 dpi in
vertical scanning direction reading mode.
50DF-RG Color displacement (R and G lines) correction value in the vertical
scanning direction at ADF reading (50 %)
Details To correct the color displacement (R and G lines) in the vertical
scanning direction at 50 % ADF reading.
When replacing the Main Controller PCB, enter the value of service
label.
Use case When replacing the Main Controller PCB
Adj/set/operate method Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
Caution After the setting value is changed, write the changed value in the
service label.
Display/adj/set range -512 to 512
Unit 0.001 line
Default value -333
Supplement/memo 50 % reading: 300 dpi in horizontal scanning direction x 600 dpi in
vertical scanning direction reading mode.
8-9
8-9