Canon D1300 Series Service Manual page 136

E Detail Item
Code Code
E736 0000 Title Communication error with CCU/modem
Detection Communication error with CCU/modem.
description NCU PCB type error.
Remedy 1. Install the set of the controller firmware.
2. Replace the NCU PCB.
3. Replace the Main Controller PCB.
E744 0001 Title Language file version error
Detection Language file version was not matched with the main program.
description
Remedy Install the set of the controller firmware.
E744 0002 Title Language file size error
Detection The size of the language file exceeded the upper limit.
description
Remedy Install the set of the controller firmware.
E744 1001 Title Firmware version error
Detection Version of the main program and the version of the start-up program
description was not matched.
Remedy Install the set of the controller firmware.
E744 4000 Title Engine ID error
Detection Invalid engine connection was detected.
description
Remedy 1. Turn OFF and then ON the main power.
2. Check the Engine Controller PCB.
3. Install the Engine Controller PCB.
4. Install the set of the controller firmware.
5. Check the model code. (When the model code and the engine code
are mismatched, E744-4000 occurs.)
E744 5000 Title Error in the Control Panel PCB
Detection Error in the Control Panel PCB (microcomputer).
description
Remedy 1. Check the Control Panel PCB, and install the firmware (PANEL).
2. Install the set of the controller firmware.
3. Replace the Main Controller PCB.
E744 6000 Title Communication error with the Wireless LAN PCB
Detection Unable to communicate with the Wireless LAN.
description
Remedy 1. Turn OFF and then ON the main power.
2. Check the connection of the Wireless LAN.
3. Install the set of the controller firmware.
4. Replace the Main Controller PCB.
E744 7000 Title Main Controller PCB error
Detection An error in the microcomputer which retains fax job information of the
description Main Controller PCB.
Remedy 1. Install the firmware of BKUP.
2. Install the set of the controller firmware.
3. Replace the Main Controller PCB.
7
Error Codes > Error Code
Description
7 Error Codes > Error Code
E Detail Item
Code Code
E746 0000 Title Main Controller PCB error
Detection Main Controller communication error occurred (other than scan).
description
Remedy 1. Install the set of the controller firmware.
2. Replace the Main Controller PCB.
E766 xxxx*1 Title Firmware error
Detection An error due to the controller software occurred so that print could not
description be proceeded.
Remedy Due to firmware error, the possibility of solving the error by replacing
the Main Controller PCB is low.
Check the installed engine again.
E766 8000 Title Digital registration error
Detection Information at digital registration could not be obtained.
description
Remedy 1. Install the Engine Controller firmware.
2. Install the set of the controller firmware.
3. Replace the Engine Controller PCB.
E766 9000 Title Scanner power state error
Detection An error was detected in power state of the Laser Scanner Unit.
description
Remedy ?
E804 0004 Title Controller Fan error
Detection Since the startup of the Controller Fan, the Fan was locked for a
description specified consecutive period of time.
Remedy 1. Check power supply to the Controller Fan.
2. Replace the Controller Fan.
E805 0000 Title Main Fan error
Detection The Main Fan was locked for a specified consecutive period of time.
description
Remedy 1. Check the connection of the Main Fan.
2. Replace the Main Fan.
E808 0000 Title Failure detection of Low Voltage Power Supply PCB
Detection Printer detected failure of the Low Voltage Power Supply PCB.
description
Remedy Replace the Engine Controller PCB.
7-4
Description
T-7-4
7-4