Security Mode Feature Set - Western Digital Ultrastar DC HC310 Specifications

9.6

Security Mode Feature Set

Security Mode Feature Set is a powerful security feature. With a device lock password, a user can prevent
unauthorized access to hard disk device even if the device is removed from the computer.
The following commands are supported for this feature.
Security Set Password
Security Unlock
Security Erase Prepare
Security Erase Unit
Security Freeze Lock
Security Disable Password
Execution of these commands is restricted for the Trusted Computing Group feature set. That is, these commands
operate only in the state that is the Manufactured-Inactivate state by the Trusted Computing Group feature set.
Moreover, these commands are aborted in the state that is activated to the Manufactured state by the Trusted
Computing Group feature set.
9.6.1 Security Mode
Following security modes are provided.
Device Locked mode
Device Unlocked mode
Device Frozen mode
9.6.2 Security Level
Following security levels are provided.
High level security
Maximum level security
9.6.3 Password
This function can have 2 types of passwords as described below.
Master Password When the Master Password is set, the device does NOT enable the Device Lock Function, and
the device can NOT be locked with the Master Password, but the Master Password can be
used for unlocking the device locked.
Identify Device Information word 92 contains the value of the Master Password Revision Code
set when the Master Password was last changed. Valid values are 0001h through FFFEh.
User Password The User Password should be given or changed by a system user. When the User Password is
set, the device enables the Device Lock Function, and then the device is locked on next power
on reset or hard reset.
The system manufacturer/dealer who intends to enable the device lock function for the end users, must set the
master password even if only single level password protection is required.
('F1'h)
('F2'h)
('F3'h)
('F4'h)
('F5'h)
('F6'h)
The device disables media access commands after power on. Media accesses
commands are enabled by either a security unlock command or a security erases unit
command.
The device enables all commands. If a password is not set this mode is entered after
power on, otherwise it is entered by a security unlock or a security erases unit command.
The device enables all commands except those which can update the device lock
function, set/change password. The device enters this mode via a Security Freeze Lock
command. It cannot quit this mode until power off.
When the device lock function is enabled and the User Password is forgotten the device
can be unlocked via a Master Password.
When the device lock function is enabled and the User Password is forgotten then only
the Master Password with a Security Erase Unit command can unlock the device. Then
user data is erased.
Western Digital Hard Disk Drive OEM Specification
48