Intercom - Bicom Systems OfficeBox End User Manual

3.9 Intercom

default, comes preset with classical music, which is played when user of the system puts
other side of the conversation on hold.
This way you are sure that the other party will not leave the conversation as music is
played while you are busy doing other things.
To continue the call that was put on hold, just press the Hold button again, this will stop
the Music On Hold and connect you back to the other call party.
If you do not like the default sound played by Music On Hold feature, please discuss it
N
with your IT administrator.
3.9 Intercom
Figure 3.8: Example: the system has two lines and the third BLF button marked on Yealink
T42G is the intercom button.
Intercom is a feature which is used in a situation when you want to announce a message to
all the other users on the system via their speakerphone.
The upside of such feature is that everyone on the system will hear your message, if they
are near a phone. This can also be a downside, as the paging
phone, which can upset people working.
To initiate intercom announcement, simply press the Intercom BLF key, after which
everyone should hear a short beep (optionally pick up the handset and talk into it). Proceed
with the announcement.
When you finish either hang up the handset or press the End Call button.
If you, as a receiver of the intercom paging, were already on a call, your current call
N
will not be interrupted. Rather, your phone will notify you via its screen that you have
another call which you can accept or ignore.
The intercom feature can be used by anyone with the phone registered to the system.
N
4
Announcing the message via a speakerphone is called paging.
4
will be answered by any idle
19