Figure 6-11: Removing Fxs Blade From Chassis Slot On Front Panel; Figure 6-12: Slot's Guiding Rails For Fxs Blade - AudioCodes MediaPack Series Hardware Installation Manual

g. Gently pull the FXS blade out of the chassis slot:

Figure 6-11: Removing FXS Blade from Chassis Slot on Front Panel

2. Install the new FXS blade:
a. Hold the blade on the front where the captive screws are located, making sure
that you do not touch the blades electrical components.
b. On the chassis front panel, orientate the FXS blade as shown in Figure 6-11.
c. Gently slide the blade into the slot, keeping the left side of the blade aligned with
the left guiding rail located above the captive screw socket, and ensuring that the
notch on the underside of the blade is aligned to the left of the inner guiding rule,
as shown in the figure below. Slide the FXS blade into the slot until it has
engaged with the chassis backplane:
d. On the rear panel, secure the FXS blade to the chassis by inserting the hex-
standoff screws (see Figure 6-9 for location of screws), using a 3/16-in. hex-head
nut driver. Do not tighten the screws.
e. On the front panel, secure the FXS blade to the chassis, by tightening the two
Philips-head, captive screws on the front panel of the blade. You can use a
Phillips or flathead screwdriver.
f. On the rear panel, insert the hex-standoff screws on the FXS blade, using a 3/16-
in. hex-head nut driver.
g. On the rear panel, connect the 50-pin Telco connector cables to the FXS ports of
the new FXS blade.
Hardware Installation Manual

Figure 6-12: Slot's Guiding Rails for FXS Blade

54
MP-1288
Document #: LTRT-28030