Figure 5-19: Swinging Cable Anchor Clip Away From Power Inlet; Figure 5-20: Connecting To Power; Figure 5-21: Strain Relief For Power Cord Using Cable Anchor Clip - AudioCodes MediaPack Series Hardware Installation Manual

Hardware Installation Manual

To connect the device to power:
1. Swing the cable anchor clip, located over the power inlet of the Power Supply module,
sideways, away from the power inlet to provide space for the power plug.

Figure 5-19: Swinging Cable Anchor Clip away from Power Inlet

2. Plug the female end of the AC power cord (supplied) into the power inlet.
3. Secure the power cord to the power inlet by providing strain relief, using the cable
anchor clip. Slide the cable anchor clip sideways, towards the power inlet and then
push the power cord into the cable anchor clip, as shown in the figure below. This
protects the plug from accidentally being pulled out.

Figure 5-21: Strain Relief for Power Cord using Cable Anchor Clip

Note: Strain relief for the power cord using the cable anchor clip is not mandatory.
4. Connect the male end of the power cord to a standard AC electrical outlet.
MediaPack Analog Gateways

Figure 5-20: Connecting to Power

45
5. Cabling the Device
MP-1288