Hardware Installation Manual
6
Hardware Maintenance
The device is a modular chassis and allows you to order any module as a Field
Replacement Unit (FRU). This section describes the procedures for installing or replacing
modules.
Warning:
not touch the components on the module. Instead, hold the module only on the edges
where no electrical components are located.
Avertissement:
module, ne touchez pas les composants sur le module. A la place, tenez le module par
ses extrémités où il n'y a pas de composants électriques.
Warning:
internal airflow pressure within the chassis.
6.1
Chassis Slot Assignment for Modules
This section describes the chassis' slot assignment for the different modules.
6.1.1
Front-Panel Module Slot Assignment
The figure below displays the chassis' slot assignment on the front panel for the different
modules:
Figure 6-1: Chassis Front-Panel Slot Assignment for Modules
Please adhere to the following guidelines for slot assignment of these modules:
TRUNKS (PRI), BRI, FXS, and FXO Modules:
•
The modules can be housed only in slots 1, 2, 3, 4, 5 and 6.
•
The modules must be housed in consecutive slots. In other words, if the device
houses three modules, they must occupy slots 1, 2, and 3 (no skipping of slots).
Media Gateways & SBCs
To prevent static electrical damage to the module's printed circuit board, do
Pour prévenir des dégâts d'électricité statique au circuit imprimé du
Cover all unoccupied module slots with blank panels. This ensures optimal
61
Mediant 1000B Gateway & E-SBC
6. Hardware Maintenance