Setup; Lightning Sensor Setup - ACU-RITE 01022 Instruction Manual

With lightning detector

Hide thumbs

Table of Contents

SETUP

Lightning Sensor Setup

Set the A-B-C Switch

Locate the A-B-C switch inside the

battery compartment. It can be set

to A, B or C. However, you must

select the same letter choices for the

display, 5-in-1 sensor and lightning

sensor in order for the units to

synchronize.

Install or Replace Batteries

AcuRite recommends high quality

alkaline or lithium batteries in

the wireless sensor for the best

product performance. Heavy duty

or rechargeable batteries are not

recommended.

PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE

WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.

BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment that will not be

used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used

batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire,

as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge

non-rechargeable batteries. DO NOT short-circuit the supply terminals.

The sensor requires lithium batteries

in low temperature conditions. Cold

temperatures can cause alkaline

batteries to function improperly. Use

lithium batteries in the sensor for

temperatures below -4ºF / -20ºC.

1. Slide off the battery compartment

cover.

2. Insert 4 x AA batteries into the

battery compartment, as shown.

Follow the polarity (+/-) diagram