Display Setup - ACU-RITE 06020 Instruction Manual

Display Setup

1 Set the A-B-C Switch
Locate the A-B-C switch inside
the battery compartment. Set
the A-B-C switch to A, B or C.
You must select the same letter
choices for both the display and
the sensor in order for the units
to synchronize.
2
Install or Replace Backup
Batteries (optional)
1. Remove the battery
compartment cover.
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment that will not be
used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used
batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fre,
as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge
non-rechargeable batteries. DO NOT short-circuit the supply terminals.
2. Insert 3 x AAA alkaline
3. Replace the battery cover.
3 Plug in Power Adapter
For the best performance, plug
in the power adapter as the main
power source for this product.
1
A-B-C Switch
Set to match
sensor
A B C
Install Backup
2
Batteries
(optional)
3 AAA batteries
3
Plug in Power
Adapter
4
batteries into the battery
compartment, as shown.
Follow the polarity (+/–)
diagram in the battery
compartment.
IMPORTANT:
Batteries are a
backup power
source to preserve
records in the event
of a power outage.
Power adapter is
recommended as
the primary power
source to enjoy the
full functionality of
this product.