5-In-1 Sensor Installation - ACU-RITE 01022 Instruction Manual

5-in-1 Sensor Installation Guidelines
INSTALLATION HEIGHT
(1.5 meters) off the ground, in an open area. Higher is better for wind
measurements - the National Weather Service recommends 33 feet
(10 meters) high!
MOUNTING OPTIONS
directly onto wooden posts or surfaces that are 2"x 4" or larger. The sensor
can also be mounted directly to 3/4" steel pipe (available at hardware stores
and home centers).
SOLAR CELL INSTALLATION
with the solar cell facing SOUTH. This ensures
the cell receives as much sun as possible and
orients wind direction.

5-in-1 Sensor Installation

1. Fasten mounting base (included) to a post
or pole (not included) using the 4 longer
screws included in the hardware bag.
2. Insert the mounting base into the hole on
the bottom of the sensor.
3. Make sure the arrows on the top of the
sensor are pointed in the proper direction
and the bubble level is centered. The solar
cell should be facing south to properly
orient the wind direction.
4. Fasten the sensor into the mounting base
using the 2 shorter screws included in the
hardware bag.
Basic Setup is Complete
The 5-in-1 sensor will now synchronize with the display. It may take a few
minutes for synchronization to complete. If both or one of the units appear to
be functioning improperly, please refer to the troubleshooting section.
Mount the sensor at a minimum height of 5 feet
The included mounting bracket is designed to screw
Install the sensor
The 5-in-1 sensor is now ready to use.
NO OBSTRUCTIONS
ABOVE OR AROUND
S O U
15
T H
(1.5 meters)