Throttle Handle - Husqvarna 226R Workshop Manual

Fuel system

Throttle handle

Dismantling
If the throttle is to be removed from the
handle, only screw (A) needs to be re-
moved.
If the two halves of the throttle are to be
separated, all screws must be removed.
NOTE!
When lifting off the handle half, be
careful that the spring (B) does not
get lost.
Using a screwdriver, carefully lift up the
lock preventing accidental throttle op-
eration, and slow down rotation until the
spring tension ceases.
Lift off the lock.
Note the location of the return spring.
Lift up the throttle control (C) and note
how the return spring is fi tted.
Unhook the throttle cable if it needs
replacing.
Remove the screw (D) and lift off the two
contact strips of the stop switch and the
control button (E).
3
21