Table of Contents
Advertisement
8.9 Dismantling the throttle trigger and
handle stop - LiHD60X / LiHD70X
1
Dismantle the front handle and the right chassis
half.
See Chapter 7.5 - 7.6.
2
Dismantle the rear handle.
See Chapter 10.9.
3
Lift the handle stop (A) and spring (B) out of the
handle followed by the throttle trigger.
See figure 17.
Cleaning and inspection
Clean and check the throttle trigger thoroughly. It
must always be replaced with a new one if cracked
or showing signs of other defects. Always use origi-
nal spare parts.
See figure 18.
8.10 Assembling the throttle trigger -
LiHD60X / LiHD70X
1
Place the throttle trigger (C) into the handle fol-
lowed by the handle stop (A) and spring (B).
See figure 17.
2
Assemble the rear handle.
See Chapter 10.14.
3
Assemble the right chassis half and the front
handle.
See Chapter 7.5 - 7.6.
32 – English
C
B
Fig.17
Fig.18
A
Advertisement
Chapters
Table of Contents
Troubleshooting
