Husqvarna 226R Workshop Manual page 23

3
22
Fuel system
Assembly
1. Hook the throttle cable (F) into the throt-
tle control.
2. Insert the return spring (G) in the hole in
the throttle control.
3. Position the throttle control with spring
over the bearing pin and tension the
spring.
Press the throttle control down.
4. Seat the return spring (H) in position.
5. Position the lock preventing accidental
throttle operation over the bearing pin
and tension the spring until the lock can
be slid down to engage and hold the
throttle control.
6. Check that the throttle cable and short-
circuit cables are properly seated and
will not get pinched.
7. Check that the spring (B) is in position in
the right-hand handle half.
Place the latter in its correct position
and tighten all the screws.