SYMBOL EXPLANATION Symbols WARNING! The hedge trimmer can be dangerous! Careless or incorrect use can result in serious, even fatal injury. Read through the Operator‘s Manual carefully and understand the content before using the hedge trimmer. Always use • Ear protection •...
Husqvarna AB has a policy of continuous product development and therefore reserves the right to modify the design and appearance of products without prior notice. WARNING! Under no circumstances may the design of the machine be modified without the permission of the manufacturer. Always use genuine accessories.
SAFETY INSTRUCTIONS Personal protective eqipment IMPORTANT INFORMATION • Incorrect or careless use of a hedge trimmer can turn it into a dangerous tool that can cause serious or even fatal injury. It is extremely important that you read and understand this manual.
Page 5
SAFETY INSTRUCTIONS 4. Vibration damping system The hedge trimmer is equipped with a vibration damping system, which is designed to give as vibra- tion-free and comfortable use as possible. The hedge trimmer’s vibration damping system reduces the transfer of vibrations between the engine unit/blades and the hedge trimmer’s handles.
Control, maintenance and service of the hedge trimmer’s protective equipment IMPORTANT INFORMATION • All service and repairs to the machine require special training. • This applies especially to the machine‘s safety equipment. If the machine does not meet any of he controls listed below you should contact your service workshop.
Page 7
SAFETY INSTRUCTIONS 5. Muffler • Never use a machine that has a defective muffler. • Check regularly that the muffler is secure. • If your muffler is fitted with a spark arrest screen then it should be cleaned regularly. A blocked screen leads to the engine overheating with serious damage as a result.
Contact your local petrol station to find out how to dispose of excess fuel. • The blades transport guard should always be fitted when transporting or storing the hedge trimmer. WARNING! Exercise great care when handling fuel.
Safety instructions when using the hedge trimmer WARNING! The hedge trimmer can cause serious personal injury. Read the safety instructions carefully. Learn how to use the machine. WARNING! Cutting tool. Do not touch the tool without first switching off the engine.
• Only use original spare parts when carrying out repairs. Basic working techniques • The hedge trimmer’s rear handle can be set in three positions by pulling out the catch. See figure. When the handle is adjusted the hedge trimmer should be idling or not running.
HUSQVARNA’s small, two-stroke engines. Mixing ratio 1:50 (2%). • If HUSQVARNA two-stroke oil is not available you can use a high quality two-stroke oil intended for air cooled engines. Contact your dealer when selecting an oil. Mixing ratio: 1:33 (3%).
Always move the hedge trimmer about 3 metres from the filling position before starting. Place the machine on a flat surface. Bear in mind that the blades start to move when the engine is started.
Carburettor Your Husqvarna product has been designed and manufac- tured to specifications that reduce harmful emissions. After your unit has been run 8-10 tanks of fuel the engine has broken in. To ensure that your unit is at peak perform-...
Muffler NOTE! Some mufflers are fitted with catalytic converters. See “Techni- cal data” to find out if your machine is equipped with a catalytic converter. The muffler is designed to dampen the noise level and to direct the exhaust fumes away from the user.
This should be carried out after approxi- mately every 20 working hours. Use Husqvarna special grease, No 503 98 96-01. The lubricant in the gearbox does not normally need to be replaced other than with repair.
Maintenance schedule Below follows some general maintenance instructions. If you need further information please contact your service workshop. Daily maintenance 1. Clean the outside of the machine. 2. Make sure the throttle trigger lock and the throttle function correctly from a safety point of view.
Page 18
Monthly maintenance 1. Clean the fuel tank. 2. Clean the carburettor and the area surrounding it. 3. Clean the fan wheel and the area around it. 4. Check the fuel filter and the fuel pipe, replace if necessary. 5. Check all cables and connections.
Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46 36-146500, declare under sole responsibility that the hedge trimmers Husqvarna 225H60 and 225H75 with serial numbers from year 2002 and onwards (the year is clearly stated in plain text on the type plate with subsequent serial number), are in conformity with the following standards or other normative documents following the provisions in the COUNCIL’S DIRECTIVE:...