Husqvarna 226R Workshop Manual page 35

5
34
Angle gear
2. Warm the gear housing some more if
needed.
3. Fit the input shaft.
4. Make sure the ball bearings touch bot-
tom in their positions.
505 38 17-09
5. Fit the circlip for the ball bearings on the
input shaft.
6. Assemble cutting attachment and spray
guards in the reverse order as set out
for dismantling.
Input shaft
The input shaft should be fi tted after the
output shaft has been fi tted.
1. Fit the ball bearings on the axle.
Place the outer ball bearing with the
sealed side facing outwards.
Do not forget the circlip holding the ball
bearings in place.
2. Make sure the gear housing is still hot
enough (about 140°C) after the output
shaft has been fi tted.
3. Lift the input shaft in place using a suit-
able pair of pliers or a suitable sleeve.
4. Make sure the ball bearings touch bot-
tom in their positions.
5. Fit the circlip for the ball bearings on the
input shaft.
6. Assemble cutting attachment and spray
guards in the reverse order as set out
for dismantling.