Chevrolet Sonic 2012 Body Repair Manual page 685

BACK TO CHAPTER INDEX
Steering
Intermediate Steering Shaft Replacement (NJ1)
Callout
Preliminary Procedure
Remove the steering column and the intermediate steering shaft as an assembly. Refer to
Intermediate Steering Shaft Upper Bolt
Caution: Refer to
1
Fastener Caution
Tighten
49 N·m (36 lb ft)
Intermediate Steering Shaft
Procedure
1. Use paint in order to place match marks on the intermediate steering shaft and on the steering column
shaft.
2. If you are replacing the intermediate steering shaft or the steering column, copy the match marks from the
2
old parts to the new parts.
3. Align the match marks as you install the intermediate steering shaft to the steering column shaft.
4. After the installation is complete, perform the following tasks:
Setup the power steering control module. Refer to . Center the steering angle sensor. Refer to .
2.1. Setup the power steering control module. Refer to
Setup
2.2. Center the steering angle sensor. Refer to
Component Name
.
.
© 2011 General Motors. All rights reserved.
STEERING
Steering Column Replacement
Power Steering Control Module Programming and
Steering Angle Sensor Centering
CHEVROLET SONIC 2012 BODY REPAIR MANUAL
TO MODEL INDEX
.
.
0-9