Chevrolet Sonic 2012 Body Repair Manual page 465

BACK TO CHAPTER INDEX
Lighting
Brake Pedal Position Sensor Replacement
Removal Procedure
1. Remove the instrument panel lower trim pad cover. Refer to
2. Disconnect the brake pedal position sensor electrical connector.
3. Remove the brake pedal position sensor bolt (1).
4. Remove the brake pedal position sensor.
Installation Procedure
Note: Ensure the fork of the brake pedal position sensor is positioned over the brake pedal post.
1. Install the brake pedal position sensor to the brake pedal bracket.
Caution: Refer to Fastener Caution
2. Install the brake pedal position sensor bolt (1) and tighten to 3 N·m (27 lb in).
3. Connect the brake pedal position sensor electrical connector.
4. Calibrate the brake pedal position sensor. Refer to
5. Install the instrument panel lower trim pad cover. Refer to
BODY SYSTEMS
Instrument Panel Lower Trim Pad Cover Replacement
.
Brake Pedal Position Sensor Calibration
Instrument Panel Lower Trim Pad Cover Replacement
© 2011 General Motors. All rights reserved.
CHEVROLET SONIC 2012 BODY REPAIR MANUAL
TO MODEL INDEX
.
.
.
0-4