Chevrolet Sonic 2012 Body Repair Manual page 375

BACK TO CHAPTER INDEX
Frame and Underbody
Drivetrain and Front Suspension Frame Replacement
Special Tools
• EN-45059 Angle Meter
• CH-50619 Front Suspension Frame Adjusting Pins
For equivalent regional tools, refer to
Removal Procedure
1. Support the radiator and condenser from above using the upper brackets on each side.
2. Raise the vehicle on a hoist. Refer to
3. Remove the front tire and wheel assembly. Refer to
4. Remove the skid plate from the front frame, if equipped. Refer to
Replacement .
5. Remove the left and right front wheel house liner inner front extensions. Refer to
Extension Replacement
6. Remove the front bumper impact bar lower bracket. Refer to
7. Disconnect the steering linkage tie rod end from the steering knuckle. Refer to
8. Disconnect the lower ball joints from the steering knuckles. Refer to
9. Disconnect the stabilizer links from the strut assemblies.
10. Remove the steering rack retaining bolts (1) and discard.
11. Using mechanics wire, secure the power steering gear to the vehicle.
12. Disconnect the hydraulic power steering hoses from the front frame, if equipped.
13. Disconnect the exhaust isolators (2) from the front suspension frame.
14. Disconnect the power brake booster pump hose and connector, if equipped.
15. Remove the rear transmission mount bracket to rear mount through bolt (1).
16. Using a suitable support table or equivalent, support the front suspension frame.
17. Remove the upper frame suspension retaining bolts (1).
BODY REPAIR
Special Tools .
Lifting and Jacking the Vehicle
Tire and Wheel Removal and Installation
.
CHEVROLET SONIC 2012 BODY REPAIR MANUAL
.
.
Drivetrain and Front Suspension Frame Skid Plate
Front Wheelhouse Liner Inner Front
Front Bumper Impact Bar Lower Bracket Replacement
Steering Linkage Outer Tie Rod Replacement .
Lower Control Arm Replacement .
TO MODEL INDEX
0-3
.