Table of Contents
Advertisement
TJ
REMOVAL AND INSTALLATION (Continued)
Fig. 66 Front Carpet
INSTALLATION
(1) Position the carpet in the vehicle
(2) Engage the snaps around under front seats.
(3) If equipped, Install the retainers attaching the
carpet to the dash panel.
(4) Install the screws attaching the console to the
floor pan.
CENTER CARPET
REMOVAL
(1) Disengage the snaps under front seats.
(2) Remove the carpet.
INSTALLATION
(1) Position the carpet in the vehicle.
(2) Engage the snaps under front seats.
CARGO AREA CARPET
REMOVAL
(1) Position the rear seat in the full forward posi-
tion.
(2) Pull the carpet from under the rear seat.
(3) If equipped, remove the Add-A-Trunk.
(4) Route the rear seat belt buckles through the
cargo area carpet.
(5) Separate the carpet from the vehicle (Fig. 67).
INSTALLATION
(1) Position the carpet in the vehicle.
(2) Route the rear seat belt buckles through the
cargo area carpet.
(3) If equipped, install the Add-A-Trunk.
(4) Return the rear seat to the full rearward posi-
tion.
WHEELHOUSE CARPET
REMOVAL
(1) Position the rear seat in the full forward posi-
tion.
(2) If equipped, remove the Add-A-trunk.
(3) Grasp wheelhouse carpet and remove from
vehicle (Fig. 67).
INSTALLATION
(1) Position wheelhouse carpet in vehicle and
adjust as necessary.
(2) If equipped, install the Add-A-trunk.
(3) Return the rear seat to the full rearward posi-
tion.
SPORT BAR
REMOVAL
(1) Remove hard top and/or soft top.
(2) Remove the door opening frames.
(3) Remove the sunvisors.
(4) Remove the A-pillar weatherstrips strips (Fig.
68).
(5) Disengage center support bar cover zipper.
(6) Remove the bolts attaching the side support
bars to the center support bar (Fig. 69).
(7) Remove the bolts attaching the side support
bars to the windshield frame.
(8) Separate the side support bars from the vehi-
cle.
(9) Pull back the center section of the carpet and
remove the bolts attaching the sport bar to the cargo
floor panel.
(10) Lower the rear seat and lift rear seat to the
full forward position.
(11) Pull back wheelhouse carpet and remove bolts
attaching the directional cross bars to the wheel-
house.
(12) Remove the bolts attaching the seatbelt
anchors to the wheelhouse.
(13) Disconnect sound bar. Refer to Group 8F,
Audio Systems for removal and installation proce-
dures.
(14) Carefully lift the sport bar upward and
remove it from the vehicle.
(15) If necessary, remove the pads and covers from
the sport bar.
INSTALLATION
(1) If necessary, transfer all attached components.
(2) Clean the base plate contact surface areas on
the floor and wheelhouse panels.
(3) Apply epoxy chromate primer to the attaching
hole edges for protection against corrosion.
BODY
23 - 37
Advertisement
Chapters
Table of Contents
