Jeep Wrangler 1999 Electronic Service Manual page 845

21 - 110 TRANSMISSION AND TRANSFER CASE
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 50 Rear Servo and Rear Clutch Check Balls
Fig. 51 Shuttle Valve End Plate
Fig. 52 Shuttle Valve E-Clip And Secondary Spring
(23) Remove governor plug end plate (Fig. 53).
(24) Remove 1-2 and 2-3 shift valve governor plugs
from valve body (Fig. 53).
(25) Remove shuttle valve throttle plug, primary
spring and shuttle valve from valve body (Fig. 53).
(26) Remove screws attaching kickdown limit
valve body to valve body (Fig. 53).
(27) Remove 1-2 shift control valve and spring
from valve body (Fig. 53).
(28) Remove 2-3 shift valve and spring from valve
body (Fig. 53).
(29) Remove 1-2 shift valve and spring from valve
body (Fig. 53).
(30) Remove throttle pressure plug from kickdown
limit valve body (Fig. 53).
(31) Remove retainer from end of kickdown limit
valve body (Fig. 53).
(32) Remove kickdown limit valve and spring from
kickdown limit valve body (Fig. 53).
(33) Remove regulator valve end plate from valve
body (Fig. 53).
(34) Remove regulator valve line pressure plug,
pressure plug sleeve, regulator valve throttle pres-
sure plug and spring (Fig. 53).
ASSEMBLY
Clean and inspect all valve body components for
damage or wear. Refer to the Cleaning and Inspec-
tion section of this group for proper procedure.
CAUTION: Do not force valves or plugs into place
during reassembly. If the valve body bores, valves,
and plugs are free of distortion or burrs, the valve
body components should all slide into place easily.
In addition, do not overtighten the transfer plate
and valve body screws during reassembly. Over-
tightening can distort the valve body resulting in
valve sticking, cross leakage and unsatisfactory
operation. Tighten valve body screws to recom-
mended torque only.
(1) Lubricate valve body bores, valves and plugs
with Mopar ATF Plus 3, Type 7176, transmission
fluid.
(2) Install regulator valve line pressure plug, pres-
sure plug sleeve, regulator valve throttle pressure
plug, and spring into valve body (Fig. 53). Verify
valve components slide freely.
(3) Install regulator valve end plate on valve body
(Fig. 53).
(4) Install kickdown limit valve and spring in kick-
down limit valve body (Fig. 53). Verify valve compo-
nents slide freely.
TJ