Table of Contents
Advertisement
TJ
REMOVAL AND INSTALLATION (Continued)
(5) Install bolt 7604 through remover, bushing and
receiver.
(6) Install Long Nut 7603 and tighten nut too pull
bushing out of the axle bracket.
Fig. 4 Bushing Removal
(7) Remove nut, bolt, receiver, remover and bush-
ing.
NOTE: On 4x2 vehicle and right side of 4x4 vehicle,
leave Spacer 7932-3 in position for bushing instal-
lation.
INSTALLATION
(1) Place Receiver 7932-1on the other side of the
axle bracket.
(2) Position new bushing up to the axle bracket.,
and large end of Remover/Install 7932-2 against the
bushing (Fig. 5).
(3) Install bolt 7604 through receiver, bushing and
installer.
(4) Install Long Nut 7603 and tighten nut to draw
the bushing into the axle bracket.
Fig. 5 Bushing Installation
(5) Remove tools and install the upper suspension
arm.
STABILIZER BAR
REMOVAL
(1) Remove upper link nuts (Fig. 6) and separate
the links from the stabilizer bar with Remove
MB-990635.
(2) Remove front bumper valence, refer to Group
23 Body for procedure.
(3) Remove stabilizer retainer bolts (Fig. 6) and
remove retainers.
(4) Remove stabilizer bar.
(5) Remove lower link nuts and bolts and remove
links (Fig. 6).
Fig. 6 Stabilizer Bar
INSTALLATION
(1) Center stabilizer bar on top of the frame rails
and install retainers and bolts. Tighten bolts to 54
N·m (40 ft. lbs.).
(2) Position links on axle brackets and into the
stabilizer bar. Install lower link bolts and nuts and
tighten to 95 N·m (70 ft. lbs.).
(3) Install upper link nuts and tighten to 61 N·m
(45 ft. lbs.).
(4) Install bumper valence.
TRACK BAR
REMOVAL
(1) Raise and support the vehicle.
(2) Remove the cotter pin and nut from the ball
stud end at the frame rail bracket (Fig. 7).
(3) Use a universal puller tool to separate the
track bar ball stud from the frame rail bracket.
(4) Remove the bolt and flag nut from the axle
bracket (Fig. 7). Remove the track bar.
SUSPENSION
2 - 9
Advertisement
Chapters
Table of Contents
