Jeep Wrangler 1999 Electronic Service Manual page 973

23 - 36 BODY
REMOVAL AND INSTALLATION (Continued)
(2) Pull on the rear seat latch to disengage the
rear seat from the striker.
(3) Lift the rear seat to the forward tumble posi-
tion.
(4) Remove the hitch pins from the seat frame
pivot pins.
(5) Slide the seat to the left to disengage the pivot
pin from the pivot bracket.
(6) Slide the seat to the right to disengage the
opposite pivot pin from the pivot bracket (Fig. 64).
(7) Remove the seat through the passenger door
opening.
INSTALLATION
(1) Position the seat on the rear floor panel and
engage the seat frame pivot pins with the pivot
brackets.
(2) Install the hitch pins on the seat frame pivot
pins.
(3) Move the seat back to the latch position and
engage the strikers with the latch brackets.
ADD-A-TRUNK
REMOVAL
(1) Release latches under trunk panel and lift
panel up.
(2) Remove bolts attaching trunk to inner body
panel (Fig. 65).
(3) Separate trunk from vehicle.
Fig. 64 Rear Seat
INSTALLATION
(1) Position the trunk in the cargo space.
(2) Install the bolts.
FRONT CARPET
REMOVAL
(1) Remove the screws attaching the console to the
floor pan.
(2) Remove the retainers attaching the carpet to
the dash panel (Fig. 66).
(3) Disengage the snaps under front seats.
(4) Remove carpet from the vehicle
Fig. 65 Add-A-Trunk
TJ