Frame Rail - Jeep Wrangler 1999 Electronic Service Manual

13 - 2 FRAME AND BUMPERS
REMOVAL AND INSTALLATION (Continued)
FRONT BUMPER
REMOVAL
(1) If equipped, disconnect the fog lamp harness
connector.
(2) Remove the screws that attach the bumper to
the frame rail (Fig. 3).
(3) If equipped, remove the tow hook.
(4) Separate the bumper from the vehicle.
Fig. 3 Front Bumper Components
INSTALLATION
(1) Position the bumper on the vehicle.
(2) If equipped, install the tow hook.
(3) Install the screws that attach the bumper to
the frame rail. Tighten the screws to 104 N·m (77 ft.
lbs.) torque.
(4) If equipped, Connect the fog lamp harness con-
nector.
REAR BUMPER EXTENSION
REMOVAL
(1) Remove the screws attaching the bumper
extension to the bumper (Fig. 4).
(2) Separate the extension from the bumper.
Fig. 4 Rear Bumper Components
INSTALLATION
(1) Position the extension on the bumper.
(2) Install the screws attaching the bumper exten-
sion to the bumper.
REAR BUMPER
REMOVAL
(1) Remove the bolt attaching the bumper to frame
rail (Fig. 4).
(2) If equipped, separate the rear tow eye from the
bumper.
(3) Remove the nuts attaching the bumper to the
rear frame crossmember.
(4) Separate the bumper from the vehicle.
INSTALLATION
(1) Position the bumper on the vehicle.
(2) Install the nuts attaching the bumper to the
rear frame crossmember. Tighten the nuts to 67 N·m
(50 ft.lbs.) torque.
(3) If equipped, position the rear tow eye on the
bumper.
(4) Install the bolt attaching the bumper to frame
rail. Tighten the bolts to 67 N·m (50 ft.lbs.) torque.
TJ