Frame Rail - Jeep Wrangler 1999 Electronic Service Manual

Hide thumbs Also See for Wrangler 1999:

Table of Contents

REMOVAL AND INSTALLATION (Continued)

(1) Raise and support the vehicle.

(2) Remove the bolt and nut from the frame rail

bracket (Fig. 7).

(3) Remove the bolt from the axle bracket (Fig. 7)

and remove the track bar.

Fig. 7 Rear Track Bar

INSTALLATION

(1) Install the track bar in the axle bracket and

install the bolt loosely.

(2) Install the track bar in the frame rail bracket

and loosely install the bolt and nut.

NOTE: It may be necessary to pry the axle assem-

bly over to install the track bar.

(3) Remove supports and lower the vehicle.

(4) Tighten the track bar nut/bolt at both ends to

100 N·m (74 ft. lbs.).

SPECIFICATIONS

TORQUE CHART

Shock Absorber

Upper Bolts . . . . . . . . . . . . . . . 31 N·m (23 ft. lbs.)

Lower Nut . . . . . . . . . . . . . . . 100 N·m (74 ft. lbs.)

Suspension Arm Lower

Axle Bracket Nut . . . . . . . . 177 N·m (130 ft. lbs.)

Frame Bracket Nut . . . . . . . 177 N·m (130 ft. lbs.)

Suspension Arm Upper

Axle Bracket Nut . . . . . . . . . . 75 N·m (55 ft. lbs.)

Frame Bracket Bolt . . . . . . . . 75 N·m (55 ft. lbs.)

Stabilizer Bar

Retainer Bolts . . . . . . . . . . . . . 54 N·m (40 ft. lbs.)

Link Nut/Bolt . . . . . . . . . . . . . 54 N·m (40 ft. lbs.)

Frame Bracket Nut . . . . . . . . 100 N·m (74 ft. lbs.)

Axle Bracket Bolt . . . . . . . . . 100 N·m (74 ft. lbs.)

Chapters

Table of Contents