Two Point Calibration With A Micro Piston Pump; Two Point Calibration With A Pulse Pump; Chemical Cleaning - Hach POLYMETRON 8810 User Manual

8.1.2 Two point calibration with a micro piston pump

8.1.3 Two point calibration with a pulse pump

8.2 Chemical cleaning

Figure 12 Chemical cleaning option
®
1 Tygon tubing
2 Measurement cell cover
Electrocution hazard. Always make sure the analyzer is turned off and power is disconnected
before installing this option.
To install the pump, refer to
To install the 10 liter canister, refer to
Electrocution hazard. Always make sure the analyzer is turned off and power is disconnected
before installing this option.
To install the pump, refer to
To install the 10 liter canister, refer to
Electrocution hazard. Always make sure the analyzer is turned off and power is disconnected
before installing this option.
This option allows the addition of a chemical cleaning solution during rinsing. The kit
includes a pump and a 10 liter canister equipped with a level detector and strainer.
3 Plastic nipple
®
4 Tygon
Install the option as follows (the numbers in brackets refer to
1. Install the pump on the rear of the panel (position 7 in
2. Dismount the transparent cell from its cover.
®
3. Insert the Tygon tubing (1) into one of the 5 holes in the measurement cell cover (2).
4. Insert the plastic nipple (3) into the end of the tube under the cell cover.
D A N G E R
Micro piston pump on page 47.
Canister kit
D A N G E R
Pulse pump on page 48.
Canister kit
D A N G E R
tubing
Additional options
on page 48.
on page 48.
5 Electric cable
Figure 12):
Figure 10 on page 37).
39