Mircom FX-2000 Series User Manual page 24

Front Panel Menu Operation
Unbypassing an active loop
When you unbypass a loop that went into alarm while it was bypassed, you will see the following
message:
If you select "yes" to unbypass this loop, the system will immediately go into alarm. To avoid this
problem, press the System Reset button before unbypassing the loop.
Relay Disconnect
This option is useful if you want to disconnect or reconnect the aux relays.
Step 1: Select Relay Disconnect
- Bypass Menu
-
1 Device /
Circuit
Step 2: Select "yes" or "no"
Common aux
relays
currently
connected
At this point the display will vary, depending on your choice:
• If you selected "yes", the display will either show the message "Relays disconnected" or
"Relays reconnected", then it will return to the Command Menu.
• If you selected "no", the display will show the message "Operation cancelled", then it will
return to the Command Menu.
21
Warning: This
loop is active. Do
you really want
to unbypass it?
1. Use and
Disc".
2. Press ENTER (
1. The systems now asks you whether or not you would
like to bypass the aux relays. Use
select "yes" or "no".
2. Press ENTER (
to scroll the cursor to "Relay
) to continue.
and
) to continue.
to