Troubleshooting Reading Bar Codes - Intermec CK70 User Manual

Troubleshooting Reading Bar Codes

70 Series Mobile Computer User's Manual
Chapter 8 — Troubleshooting and Maintaining the Computer
7 Tap the RSSI tab to view the received signal strength of the host
signal.
The information box includes the current signal strength, host
SSID name, MAC address, data rate, and transmit power.
• Tap Mark to place an arrow marker above the graph.
8 Tap the Conf tab to set up a log file that lists RSSI history.
This screen includes the 802.11 radio driver version and available
radio modes.
To create a log file:
a Check the Log to File check box.
b (Optional) Change the sample period and number of samples
displayed.
c Tap Log File. The Save As screen appears.
d (Optional) Change the name of the saved log file, the folder to
which the file will be saved, the content type (log or text), and
the location.
e Tap Save.
Use this section to troubleshoot problems that may prevent you from
being able to read a bar code such as the symbology not be enabled.
Problem
You cannot see a red beam of light
from the imager when you press
the Scan button and aim the
imager at a bar code label.
Solution
•
You may be too far away from the bar
code label. Try moving closer to the bar
code label and scan it again.
•
You may be reading the bar code label
"straight on." Change the reading
angle and try again.
•
The imager hardware trigger might be
disabled in Intermec Settings. To
check the setting go to
Settings > Systems > Data
Collection > Scanner Settings
Hardware trigger should be checked.
Start >
.
107