Transmission Port Setting (Tx Port) - JRC JMA-9133-SA Installation Manual

JMA-9100/7100 Installation Manual > 3.INSTALLATION OF DISPLAY UNIT > 3.9 CONNECTIONS WITH ECDIS
Upon shipment, settings are made so that target tracking information is not
outputted. Enable the settings for outputting desired sentences with reference to
Section 7.2.1 in the instruction manual or refer to below.
To output the radar video signal to the second ECDIS, connect the device to
TB4401 (SVD1,SVD1E, ETIY1, ETIY1E, EXφB1, EXφB1E, EXφZ1, and
EXφZ1E).
3.9.1

Transmission Port Setting (TX Port)

For each sentence, set a communication port through which signals are
transmitted to sensors.
Procedures
1) Open the Serviceman Menu.
2) Perform the following menu open procedure to open the TX Port setting
menu
Fig 3-31:
Arrangement of TB4401
2. Installation Menu
→ 5. COM Port Setting
→ 4. TX Port
3－ 34
J4304
J4315
J4308
ISW
J4309
TB 2
J4305
J4312 OPE2
J4311 OPE1
COM
PC430
TERMINAL BOARD