True Bearing Setting - JRC JMA-9133-SA Installation Manual

4.6

TRUE BEARING SETTING

When a gyro signal is inputted by using GYRO I/F, there is a rare case in which
the true bearing value indicated by the master gyro does not match the true
bearing value indicated by this apparatus.
In that case, make adjustments so that the true bearing value of this apparatus
matches the true bearing value indicated by the master gyro.
Procedures
1) Open the [1.GYRO Setting] screen according to the operation shown below.
Main Menu
2) Enter the value indicated by the master gyro on the value input screen.
For how to input values on the value input screen, see Section 3.3.4 in the
instruction manual.
JMA-9100/7100 Installation Manual > 4.INITIAL SETTING > 4.6 TRUE BEARING SETTING
→ 6. NAV Equipment Setting
→ 1. GYRO Setting
4－ 11
4