Table of Contents
Advertisement
Removing and Installing Port Adapters
This chapter describes how to remove the PA-2FEISL port adapter from supported platforms and also
how to install a new or replacement port adapter. This chapter contains the following sections:
Handling Port Adapters, page 3-2
•
Online Insertion and Removal, page 3-2
•
•
Warnings and Cautions, page 3-3
Port Adapter Removal and Installation, page 3-4
•
•
Connecting a PA-2FEISL RJ-45 or SC Cable, page 3-10
Each port adapter circuit board is mounted to a metal carrier and is sensitive to electrostatic discharge
(ESD) damage.
When a port adapter slot is not in use, a blank port adapter must fill the empty slot to allow the router or
Note
switch to conform to electromagnetic interference (EMI) emissions requirements and to allow proper
airflow across the port adapters. If you plan to install a new port adapter in a slot that is not in use, you
must first remove the blank port adapter.
When powering off the router, wait a minimum of 30 seconds before powering it on again.
Caution
OL-3475-02
PA-2FEISL 100BASE-T Fast Ethernet/ISL Port Adapter Installation and Configuration
C H A P T E R
3
3-1
Advertisement
Table of Contents
