Table of Contents
Advertisement
Handling Port Adapters
Handling Port Adapters
Always handle the port adapter by the carrier edges and handle; never touch the port adapter components
Caution
or connector pins. (See
Figure 3-1
Online Insertion and Removal
Several platforms support online insertion and removal (OIR) of port adapters; therefore, you do not
have to power down routers when removing and replacing a PA-2FEISL on Cisco 7100 series routers,
Cisco 7200 series routers, or Cisco uBR7200 series routers.
Although the VIP2 and the Catalyst RSM/VIP2 support online insertion and removal,
individual port adapters do not. To replace port adapters, you must first remove the VIP2 or
Catalyst RSM/VIP2 from the chassis and then install or replace port adapters as required. If a blank
port adapter is installed on the VIP2 or Catalyst RSM/VIP2 on which you want to install a new
port adapter, you must first remove the VIP2 or Catalyst RSM/VIP2 from the chassis and then remove
the blank port adapter.
To prevent system problems, do not remove port adapters from the VIP2 or Catalyst RSM/VIP2
Caution
motherboard or attempt to install other port adapters on the motherboard when the system is operating.
To install or replace port adapters, first remove the VIP2 or Catalyst RSM/VIP2 from its interface
processor slot.
It is wise to gracefully shut down the system before removing a port adapter that has active traffic moving
through it. Removing a module while traffic is flowing through the ports can cause system disruption.
Once the module is inserted, the ports can be brought back up.
As you disengage the module from the router or switch, online insertion and removal (OIR)
Note
administratively shuts down all active interfaces in the module.
OIR allows you to install and replace modules while the router is operating; you do not need to notify
the software or shut down the system power, although you should not run traffic through the module you
are removing while it is being removed. OIR is a method that is seamless to end users on the network,
maintains all routing information, and preserves sessions.
PA-2FEISL 100BASE-T Fast Ethernet/ISL Port Adapter Installation and Configuration
3-2
Figure
3-1.)
Handling a Port Adapter
Metal carrier
Printed circuit board
Chapter 3
Removing and Installing Port Adapters
OL-3475-02
Advertisement
Table of Contents
